LIFTERS
Part# |
Description |
Valve settings AND Important Data |
Price each |
Price full set |
Original Johnson lifters #HA-951 |
Standard hydraulic cam factory style,you can use these on big cams also |
1 turn past zero lash, if the valve train is ALL stock valve lengths and you're using poly locks with the correct length push rods, then you tighten the factory nut to 22 ft. lbs with oil on the threads, for the bottle neck stud style.Then NEVER adjust them again, for the life of the engine !! DO NOT pre-pump-up ! |
$ 3.25 | $ 49.00 |
Comp High Energy Hydraulics #852 |
Standard hydraulic cam factory style,you can use these on big cams also |
1 turn past zero lash, if the valve train is ALL stock valve lengths and you're using poly locks with the correct length push rods, then you tighten the factory nut to 22 ft. lbs with oil on the threads, for the bottle neck stud style.Then NEVER adjust them again, for the life of the engine !! DO NOT pre-pump-up ! |
$ 5.00 | $ 75.00 |
Comp Pro Magnum Hydraulics #863 |
Designed for higher engine speeds |
These lifters don't pump-up like the standard lifters do. Set valves at 1/8 to 1/4 turn past zero lash. Use with adjustable valve train only !! Good to 6200 r.p.m. I use these in all the motors I build. |
$ 6.25 | $ 90.00 |
Comp Variable Duration Hydraulics #886 |
"ROADS" (spelling) For big cam motors, where you need more vacuum, hot street cars. |
These lifters have a greater bleed rate which greatly increases, vacuum,throttle response. |
$ 6.00 | $ 85.00 |
Comp Solid for flat tappet cams. # 816 |
For solid cam motors, comes with oil metering so you don't need to run restrictors |
Set according to cam card. |
$ 7.00 | $105.00 |
Comp Hydraulic roller cam lifters #857 |
For Hydraulic roller cams Comes with link bars |
DO NOT prime/ pump-up lifters. Set valves at 3/4 turn past zero lash, then NEVER adjust them again, for the life of the motor. |
$ 60.00 Comes as a pair only |
$439.00 full set with link bars |
Comp Solid roller lifter #859 |
For solid roller cams. This lifter comes with a .030" metering hole to pressure feed the needle bearings ! Comes with link bars |
Follow cam card settings. |
$ 25.00 Comes as a single lifter.. 2 for $50.00 w/link |
$350.00 |